Filter
Top Products
170
Using the MV-8000 with MIDI or V-LINK devices
Making V-LINK settings
1.
Press .
The
SYSTEM MENU screen
(p. 319) will appear.
2.
With the cursor located in the upper row of
icons, press (V-Link). Alternatively,
select the V-LINK icon and press .
The
V-LINK screen
(p. 325) will appear.
3.
Specify the MIDI transmit channel and other parameters as desired.
For details on the function of these parameters, refer to
V-LINK screen
(p. 325).
V-LINK Function chart
When V-LINK function is on, you can use the following functions.
V-LINK function
Uses
controller
Transmitted MIDI message
Changing Clip
Velocity Pads
Program change:
00H~0FH
Changing Clip Bank
[PAD BANKS]
button
CC 00 (Bank select):
00H~1FH (Audio track)
00H~05H (MIDI track)
Color (Cr) Control
(Color-difference signal)
Slider 1 CC 71 (Resonance)
Color (Cb) Control
(Color-difference signal)
Slider 2 CC 01 (Modulation)
Brightness Control Slider 3 CC 74 (Cutoff)
Dissolve Time
(Amount time the video
clips overlap)
Slider 4 CC 73 (Attack time)
VFX Control (Visual
effects)
Slider 5 CC 72 (Release time)
The MV-8000 does not support
the Edirol DV-7PR's Dual
Stream mode.
For the Control Ch parameter,
select the MIDI connector to
which your V-LINK device is
connected.
You can change the
transmitted MIDI message
used by sliders. For details
refer to V-LINK screen (p.
325).
You use [PAD BANK] to
switch banks, a CC 00 message
and Program Change are
successively transmitted when
you strike a velocity pad.
When switching palettes, the
range of selectable banks will
depend on the type of the
current track (audio track or
MIDI track).
Please also read the owner's
manual of the V-LINK device
you are using.
ECS05_manual_e.book 170 ページ ２００５年１１月３０日 水曜日 午前１１時１４分