Filter
Top Products
254
SEQUENCE
STEP REC (MIDI) screen
Here you can use the pads to record note data on a
MIDI track.
To access this screen
•+
In order to open this popup, you must specify a
MIDI track as the current track.
Explanation of each area
1.
Step Time
Specifies the note value of the notes you will input.
Range: (30), (40), (60), (80), (120),
(160), (240), (320),
(480)
,
(640), (960), (1920), (3840),
In the STEP REC screen you can change the step
time by pressing [SHIFT] + ([ (1)] ~ [ (9)])
(numeric keys).
2.
Duration
Specifies the actual length of the note, as a percentage
of the note value you specified for Step Time.
Range: 1~
100
~200 %
3.
Velocity
Specifies the strength of the note.
Range:
Real
, 1~127
4.
Note number (keyboard)
The note numbers (keys) are shown from bottom to
top. Since the actual pitches correspond to the note
numbers, the displayed location of the note tells you
the pitch.
5.
Piano roll
This shows the note events. The horizontal axis is
time, and the vertical axis is note number (pitch). The
range of shown note changes by inputting the note
number.
6.
Velocity
Indicates the velocity of the note event. The velocity is
shown as a pair with the note event; a longer bar
indicates a stronger velocity.
F-buttons
Back Step
Reverts the preceding input.
Tie
Connects (extends) the event at the current time to
the next step.
Rest
Inputs a rest (silence).
During step recording, you can press [REC] to make
the REC indicator (red) blink. In this state, pressing
the pads will not record anything. This is a
convenient way for you to check the sound
produced by each pad.
ECS05_manual_e.book 254 ページ ２００５年１１月３０日 水曜日 午前１１時１４分