Filter
Top Products
132
Creating an audio CD
• When writing the title etc. on the label surface of the disc, use a soft felt-tipped
marker.
• If the disc becomes soiled, use a soft dry cloth to wipe it lightly
from the center of the disc straight toward the outer edge. Do not
wipe in a circular direction.
• Do not use cleaning agents such as cleaners or sprays made for
vinyl records, or solvents such as benzene.
Recommended discs
• We recommend CD-R discs made by the following
manufacturers:
Taiyo Yuden Corporation, Mitsui Chemical Corporation, Mitsubishi Chemical
Corporation, Ricoh Corporation, Hitachi Maxell Corporation
• We recommend CD-RW discs made by the following manufacturers:
Mitsubishi Chemical Corporation, Ricoh Corporation
Inserting a disc
1.
Press the eject button.
2.
Open the disc tray.
3.
Align the hold of the disc with the round retainer in the center of the CD-R/RW
drive.
4.
Press the disc downward until it locks into the three catches of the retainer.
5.
Push the disc tray all the way in.
If the disc tray fails to open
If, due to a power failure or other reason, the power is turned off with a disc in the tray,
you won't be able to eject the disc tray by pressing the eject button. If this happens,
insert a straightened paper clip (or similar object) into the emergency eject hole to eject
the tray.
1.
Turn off the power of the MV-8000.
2.
Insert a straightened paper clip (or similar object) into the emergency eject
hole. The disc tray will be ejected.
Make sure that the disc is
firmly seated in the
CD-R/RW drive tray. If the
disc is not correctly in
position, it may catch
inside the drive and may be
impossible to remove.
To check whether the disc is
correctly in position, try lightly
rotating the outer edge of the
disc with your finger. Make
sure that the disc does not
come off the retainer or fail to
rotate smoothly.
Never use the emergency
eject hole to eject the disc
tray when the MV-8000 is
operating. Doing so may
damage the disc and/or
drive, and may cause the
disc to fly out.
The software locks the eject
b
utton while the MV-8000
system is using the CD-R/RW
drive. This means that pressing
the eject button in such cases
will not eject the tray. This is a
design feature for reasons of
safety, and is not a
malfunction.
ECS05_manual_e.book 132 ページ ２００５年１１月３０日 水曜日 午前１１時１４分