Filter
Top Products
271
INSTRUMENTS
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
PATCH EDIT (CONTROL) screen
MIDI messages received by the part can be used to
control various parameters of the partial, according to
the settings you make here.
To access this screen
•
➜➜
INSTRU-
MENTS
Explanation of each area
1.
Current part, current patch name
Displays the number and patch name of the currently
selected part.
2.
Control Change No (Control change number)
Specifies the control change number that is used
when you set SMT Control Select to Control Change.
The specified control change can be used to control
the pitch, filter, and amplifier sections of the sound
source.
Range: 0~
2
~127
3.
SMT Control Select
Specifies the type of MIDI message that will be used
to control SMT.
You can control SMT either by velocity or by the
above MIDI message. You cannot simultaneously
use both velocity and the above MIDI messages. If
you want to use velocity to control this, turn the
SMT Velocity Control parameter On in the
PARTIAL EDIT (SMT) screen
(p. 289).
4.
Sens (Sensitivity)
Sets the amount of the Matrix Control’s effect that is
applied. If you wish to modify the selected parameter
in a positive (+) direction – i.e., a higher value,
toward the right, or faster etc. – from its current
setting, select a positive (+) value. If you wish to
modify the selected parameter in a negative (-)
direction – i.e., a lower value, toward the left, or
slower etc. – from its current setting, select a negative
(-) value. When both positive and negative are
selected, the changes are greater as the value
increases. Set it to “0” if you don’t want this effect.
Value: -63 ~
0
~ +63
5.
Bend (Pitch bend)
Specifies the parameter that will be controlled when
Bend messages are received.
6.
Aftertouch
Specifies the parameter that will be controlled when
Aftertouch messages are received.
7.
Modulation
Specifies the parameter that will be controlled when
Modulation messages are received.
8.
Control Change
Specifies the parameter that will be controlled when
control change messages (the control change number
is specified by Control change No) are received.
Value
Explanation
Off
No control.
Bend Control by pitch bend
Aftertouch Control by aftertouch
Modulation Control by modulation
Control Change
Control by control
change (the control
change number is speci-
fied by the Control
Change No parameter)
ECS05_manual_e.book 271 ページ ２００５年１１月３０日 水曜日 午前１１時１４分