Filter
Top Products
324
SYSTEM
MIDI screen
Here you can make MIDI settings.
To access this screen
•
➜
(move the cursor to the upper row of
icons)
➜
Explanation of each area
1.
Device ID
This is a number used to distinguish between
multiple MV-8000 units connected to the same MIDI
line. In order to transmit and receive system exclusive
messages, the two units must be set to the same
device ID.
Range:
1
~32
2.
Tx Active Sensing (Transmit Active Sensing)
Specifies whether Active Sensing messages will be
transmitted on the MIDI line. This allows a receiving
device to check the connection state.
The MV-8000 does not transmit exclusive messages.
However it does transmit MTC (MIDI Time Code)
and MMC (MIDI Machine Control).
3.
Multi Timbre Sampler Mode
This setting specifies whether the MV-8000's sound
generator will be played by the internal sequencer or
by messages received from MIDI IN.
You cannot record performance data onto the
MV-8000's sequencer while Multi Timbre Sample
Mode is On.
The MV-8000 can receive and play performance
data from MIDI IN only while the following screens
are displayed.
•
SEQUENCE screen
(p. 205)
•
INSTRUMENTS screen
(p. 265) (performance data
from the velocity pads is not transmitted)
•
EFFECTS screen
(p. 372)
•
MIXER
(p. 378)
For details the Multi Timbre Sampler Mode, refer to
Using the MV-8000 in Multitimbre Sampler Mode
(p. 164).
4.
Pad Tx Channel (Pad Transmit Channel)
Specifies the MIDI connector and channel on which
performance data from the velocity pads will be
transmitted when Multi Timbre Sample Mode is On.
Range:
A-1
~A-16, B-1~B-16, R-1~R-16
R-1~R-16 are MIDI channels transmitted from
R-BUS. In order to use this setting, the MV8-OP1
(sold separately) and DIF-AT24 (sold separately)
must be installed.
Value
Explanation
Off Active Sensing will not be transmitted.
On
Active Sensing will be transmitted.
Value
Explanation
Off
Performance data from the velocity
pads and MIDI IN is sent to the se-
quencer section.
On
Performance data from the velocity
pads is sent from MIDI OUT. Perfor-
mance data from MIDI IN is sent direct-
ly to the instrument section.
ECS05_manual_e.book 324 ページ ２００５年１１月３０日 水曜日 午前１１時１４分