Filter
Top Products
115
Playing your songs
Playing your songsEditing a songCreating a song (Song Recording) Using effects Adjusting the balance of your song and
mastering it
3.
Use (left/right) to move the cursor to the “S” column.
“S” is the Solo switch; it controls the Solo function of the track.
4.
Turn the VALUE dial toward the right or press .
“S” will be displayed at the cursor location of the current track. Solo is now on.
Changing various track playback settings
You can control the playback in various ways by switching track parameters.
Changing the sound generator that each track plays
By specifying the output destination of a track, you can use different internal sounds
or external sound modules to play the song.
1.
Press .
The
SEQUENCE screen
(p. 205) will appear.
2.
Use (up/down) to make the track whose settings you will change the
current track.
The current track is highlighted.
3.
Press (Track Param).
The
TRACK PARAMETER (MIDI) popup
(p. 208) or
TRACK PARAMETER (AUDIO)
popup
(p. 210) for the current track will appear.
4.
Set the parameters.
This will change the sound generator used by the track.
Parameter
Explanation
Output Assign
Specifies the internal sound generator (part number) the
track will play.
MIDI
Specifies the MIDI connector and channel number on
which the track will be transmitted from MIDI OUT.
If you turn both Mute and Solo
on for the same track, Solo will
take priority.
To defeat Solo, turn the
VALUE dial toward the left or
press [DEC] to switch the “S”
indicator to “-”.
ECS05_manual_e.book 115 ページ ２００５年１１月３０日 水曜日 午前１１時１４分