Filter
Top Products
71
Editing a sampled sound
Editing a sampled soundMain FeaturesContents Parts of the MV-8000 and what they do Sampling
To create a patch by dividing an audio phrase (Chop)
1.
Perform the steps described in
Accessing the Audio Phrase Edit screen
(p. 68).
The
AUDIO PHRASE EDIT screen
(p. 303) will appear.
2.
Press (Chop).
The
CHOP popup
(p. 305) will appear.
3.
Specify the Current Address and press
(Add Point).
The phrase will be divided at the Current Address
you specify. Each dividing point is assigned a point
number, and stores the time location you assign. If
you want to assign additional dividing points,
repeat step 3.
4.
Press (Execute).
The audio phrase will be divided at the time location(s) you specified. The
QUICK
ASSIGN (CHOP) popup
(p. 307) will appear.
5.
Specify a pad bank.
Specify the pad bank and pad number to which the divided waveform will be
assigned.
6.
Press (Set).
The divided waveform will be assigned to pad numbers 1 and following of the
specified pad bank.
Other ways to edit audio phrases
In the same way as when editing samples, you can use the Emphasis (p. 61), Normalize
(p. 61), Time Stretch (p. 62) and Truncate (p. 62) to edit an audio phrase.
To access the sample edit commands
To use “Emphasis,” “Normalize,” “Time Stretch,” or “Truncate” access the “Sample
Edit Command” list.
1.
Perform the steps described in
Accessing the Audio Phrase Edit screen
(p. 68).
The
AUDIO PHRASE EDIT screen
(p. 303) will appear.
2.
Press (Command).
The
SELECT SAMPLE EDIT COMMAND popup
(p. 283) will appear. The procedure is the same as
when editing a sample.
• Emphasis
To emphasize or reduce the high-frequencies of
the sample (Emphasis)
(p. 61)
• Normalize
To maximize the level of a sample (Normalize)
(p. 61)
• Time Stretch
To change the length or tempo of a sample (Time Stretch)
(p. 62)
• Time Stretch
To change the length or tempo of a sample (Time Stretch)
(p. 62)
You can assign up to fifteen
points (i.e., divide the audio
phrase into sixteen pieces).
Each of the divided waveforms
is assigned to a pad as a
drum-type partial.
If you want the dividing points
to be determined
automatically according to
certain conditions, press [F3
(Auto Chop)]. The AUTO
CHOP popup will appear. For
details on the parameters
(conditions) you can set, refer
to the AUTO CHOP popup (p.
306).
ECS05_manual_e.book 71 ページ ２００５年１１月３０日 水曜日 午前１１時１４分