Filter
Top Products
356
SAMPLING
8.
Length
Specifies the time after which sampling will stop.
• The Length setting is used only when Stop
Trigger= Beat or Time.
• The maximum value for Length depends on the
remaining amount of sampling memory.
9.
Pre Sample Time
Specifies how much time prior to the actual start of
sampling will be captured in the sample.
Range:
0
, 20, 40, 80, 160, 320, 640, 1000 ms
10.
Auto Divide
The Auto Divide function detects regions of silence
within the sample, and divides the sample into
several samples at these points.
Range:
Off
, On
11.
Gap Time
When Auto Divide=On, this parameter specifies the
length of the silent regions that will be detected.
Range:
0.5
, 1.0, 1.5, 2.0 sec
The Gap Time setting is used only when Auto
Divide=On.
12.
Auto Emphasis
Automatically pre-emphasis processes after
sampling.
Range:
Off
, On
13.
Auto Normalize
Automatically normalizes the level after sampling.
Range:
Off
, On
14.
Wave Memory
Indicates the amount of wave data stored in the
DIMM, both numerically and as a graph.
F-buttons
Sampling
Samples an external audio source. The SAMPLING
screen will appear.
Re-Sampling
Samples an internal audio source. The RESAMPLING
screen will appear.
Reset Peak
Clears the indicators of the peak hold in the Level
meters.
Start
Starts sampling.
If Start Trigger=Manual, sampling will begin
immediately. Otherwise, sampling will begin
according to the conditions specified by the Start
Trigger setting.
When Start Trigger = Level/Play/Pad
Cancel
Cancels the sampling operation.
Start
Manually starts sampling. A message of Now
Sampling... will appear.
When Start Trigger=Manual, or during sampling
Cancel
Cancels the sampling operation.
Stop
Stops sampling. The Sampling Result screen will then
appear.
Stop Trigger
parameter
Value
Beat 1~
8
~20000
Time
000m01s~
000m02s
~
100m00s
Sampling type
Screen that appears
Audio phrase/
patch
SAMPLING RESULT (AUDIO
PHRASE/PATCH) popup
(p.
357)
Sample
SAMPLING RESULT (SAM-
PLE) popup
(p. 359)
ECS05_manual_e.book 356 ページ ２００５年１１月３０日 水曜日 午前１１時１４分