Filter
Top Products
211
SEQUENCE
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
RECORDING PARAMETER (MIDI) popup
Here you can set parameters for recording onto a
MIDI track.
To access this screen
•
➜
•
➜
In order to open this popup, you must specify a
MIDI track as the current track.
Explanation of each area
1.
Rec Mode (Recording mode)
Specifies how recording will occur
2.
Count In
Specifies how recording will start.
3.
Auto Punch In / Auto Punch Out
You can specify two time locations at which
recording will automatically start and stop (“auto
punch”).
You cannot set Auto Punch In to a location after
Auto Punch Out.
Make loop settings in the
LOOP popup
(p. 240).
4.
Metronome Mode
Specifies when the metronome signal will be output.
5.
Input Quantize Type
You can apply quantization while you record, so that
the corrected data is recorded on the sequencer track.
6.
Strength (Quantize strength)
Specifies the strength of synchronization applied to
the notes specified by Grid Quantize Resolution or
Shuffle Quantize Resolution. Higher values will
adjust the notes further toward the locations specified
by the Grid Quantize Resolution or Shuffle Quantize
Resolution parameter.
Range: 0~
100
%
A setting of 100 produces the strongest effect; a
Value
Explanation
Overdub
Newly recorded data will be added to
the previously-recorded data.
Replace
Newly recorded data will replace the
previously-recorded data.
Value Explanation
Off
Recording will begin the instant you press
[PLAY]. (There will be no count.)
1 Meas
Recording will begin after a one-measure
count.
2 Meas
Recording will begin after a two-measure
count.
Parameter
Value
Auto Punch In
(
Loop Start time
) ~ (Loop
End time)
Auto Punch Out
(
Auto Punch In time
) ~
(Loop End time)
Value
Explanation
Off
The metronome will not sound.
Rec Only
The metronome will sound only during
recording.
Play&Rec
The metronome will sound during play-
back and recording.
Always The metronome will always sound.
Value
Explanation
Off
Input quantization will not be used.
Grid
The sequence data will be adjusted to the
timing intervals specified by the Grid Quan-
tize Resolution parameter.
Shuffle
Shuffle quantization will be used. The se-
quence data will be adjusted forward or
backward relative to the timing intervals
specified by Shuffle Quantize Resolution, by
the amount specified by Shuffle Quantize
Rate.
This can give the beat a bouncy feel,
such as “shuffle” or “swing.”
ECS05_manual_e.book 211 ページ ２００５年１１月３０日 水曜日 午前１１時１４分