Filter
Top Products
68
Editing a sampled sound
Editing the settings of an audio phrase
While an Instrument is used mainly to play individual notes, an Audio Phrase is best
suited for handling audio data of an appreciable length. For example, you might use
various audio phrases containing drum patterns and guitar chording patterns to create
the framework of your song. Since the MV-8000 lets you modify the tempo or length
of an audio phrase without affecting its pitch, the phrases will keep the correct pitch
even if you change the tempo of the sequencer.
Accessing the Audio Phrase Edit screen
1.
Press .
The
AUDIO PHRASES (PAD) screen
(p. 301) will
appear.
2.
Press the for the audio phrase you
want to edit.
3.
Press (Edit).
The
AUDIO PHRASE EDIT screen
(p. 303) screen will appear, allowing you to edit the
audio phrase.
To change the playback start point or loop-playback point of the
phrase
Here's how to specify the playback start point and the playback region of an audio
phrase. The specified loop region will play back repeatedly.
1.
Perform the steps described in
Accessing the Audio Phrase Edit screen
(p. 68).
The
AUDIO PHRASE EDIT screen
(p. 303) will appear.
2.
Set the Start Point parameter.
This specifies the point at which the phrase will begin playing.
3.
Set the Loop Point parameter.
If you want to make settings
for an audio phrase of a
different bank, switch the pad
b
ank before you strike a pad.
To switch the pad bank, refer
to To switch to a different
pad bank (p. 73).
You can also select an audio
phrase by moving the cursor to
the pad on the screen.
Specifies
the volume.
Adjusts the pitch.
Specifies a partial assigned
to the same exclusive group number
are played simultaneously.
Specifies
the start point
at which the phrase
will begin playing.
Specifies
the loop playback
start point
of the waveform.
Specifies the point
at which the phrase
will stop playing
or will return
to the loop point.
Indicates the magnification
of the waveform shown
in the wave window.
If this parameter is On,
the sequencer
and the audio phrase
will play in synchronization.
If this parameter is On,
the audio phrase
will play backward.
If this parameter is On,
the velocity function
will be used
when you play the pads.
Specifies the length
as a number of beats
at the specified note value.
Specifies the play region
of the waveform.
Specifies how the audio phrase
will play when you play the pads.
The value displayed here is calculated
from the BPM Base Note setting
and the number of beats
in the Start-End region.
Displays the audio phrase (waveform)
that you are editing.
If you want to use looping, set
the Loop Mode parameter to
“Loop-End.”
ECS05_manual_e.book 68 ページ ２００５年１１月３０日 水曜日 午前１１時１４分