Filter
Top Products
57
Editing a sampled sound
Editing a sampled soundMain FeaturesContents Parts of the MV-8000 and what they do Sampling
The sound of the partial will be sent to the delay/chorus effect and/or to the reverb
effect.
You can change the type of delay/chorus or reverb. For details, refer to
To use
effects (delay/chorus, reverb)
(p. 48).
To adjust the pitch
➜
adjust the Pitch parameters.
Coarse adjusts the pitch broadly, and Fine makes fine adjustments.
To use the filter
The filter affects the brightness or fatness of the sound by cutting a specific region of
frequencies.
1.
Adjust the Filter parameter Type.
The Type parameter selects the type of filter that will be used.
2.
Adjust the Filter parameters Cutoff, Reso, A, and R.
The Cutoff parameter specifies the frequency at which the filter will be applied. The
Reso parameter adds a boost at the frequency specified by the Cutoff parameter. For
details on the other parameters, refer to
PARTIAL EDIT screen
(p. 276).
3.
If you want to make more detailed edits, press (Filter).
The
PARTIAL EDIT (FILTER) screen
(p. 291) will appear.
To adjust the way in which the volume changes
1.
Adjust the Amplifier parameters A, D, S, and R.
For details on these parameters refer to
PARTIAL EDIT screen
(p. 276).
2.
If you want to make more detailed edits, press (Amplifier).
The
PARTIAL EDIT (AMPLIFIER) screen
(p. 294) will appear.
To add modulation to the sound
1.
Adjust the value shown below the LFO (Low Frequency Oscillator) icon.
This selects the type of waveform that the oscillator will produce (p. 276).
2.
Adjust the Rate parameter.
Higher settings will produce faster modulation.
3.
Adjust the Depth parameter.
Higher settings will produce greater amplitude or pitch modulation.
4.
If you want to make more detailed edits, press (LFO).
The
PARTIAL EDIT (LFO) screen
(p. 296) will appear.
When you're in the PARTIAL
EDIT screen, the top panel
sliders 1~4 correspond to the
Cutoff, Reso, A, and R
parameters respectively.
When you're in the PARTIAL
EDIT screen, the top panel
sliders 5~8 correspond to the
A, D, S, and R parameters
respectively.
ECS05_manual_e.book 57 ページ ２００５年１１月３０日 水曜日 午前１１時１４分