Filter
Top Products
220
SEQUENCE
AUDIO EVENT PARAMETER popup
Here you can adjust the parameters of the event at the
current time location within an audio track.
To access this screen
•
➜➜
(Select the Audio track)
➜➜
(Select Audio Event Parameter)
➜
In order to open this popup, you must specify an
audio track as the current track.
Explanation of each area
1.
Position
Displays the starting time of the event.
2.
Duration
Specifies the length of the individual event.
Range: 0000-01 (1 tick)~
9999-*** (9999 beats *** ticks)
3.
Sample
Indicates the sample number that exists at the current
time location.
4.
Level
Specifies the volume of the audio event.
Range: 0~
127
5.
Coarse Tune
Adjusts the pitch of the audio event in semitone
steps.
Range: -48~
0
~+48 (+/-4 octaves)
6.
Fine Tune
Adjusts the pitch of the audio event in one-cent steps.
Range: -50~
0
~+50
One cent = 1/100th of a semitone
7.
BPM Sync
Selects whether the playback speed of the audio event
will be adjusted in realtime according to sequencer
tempo changes. If this is On, tempo changes will
shorten or lengthen the phrase in realtime.
Range:
Off
, On
8.
BPM
Specifies the tempo of audio event. When BPM Sync
parameter is on, audio event played by this BPM
setting.
Range: 5.00~
100.00
~300.00
F-buttons
Move
Displays the MOVE AUDIO EVENT popup. Then
specifies the move-destinaion that moves the audio
event at the current time location.
Close
Closes the AUDIO EVENT PARAMETER popup.
ECS05_manual_e.book 220 ページ ２００５年１１月３０日 水曜日 午前１１時１４分