Filter
Top Products
427
Effect Block
Preset patches and Algorithm list Effect Block MIDI Implementation Specifications Index
GtrAmp (Guitar amp modeling)
This simulates the sound of a guitar amplifier.
1.
Mode
This selects the guitar amp type.
Delay
The digital delay can be switched between monaural
and alternate modes (left and right channels
mutually).
1.
Mode
Value: Mono, Alt
This switches the mode of the delay.
2.
Delay Time
Value: 1–1200 (Mono), 1–600 (Alt) msec
Sets the delay time, that is, the elapsed time between
the source sound and the delay sound. This setting is
not effective during Tempo Sync, and you cannot
make this setting.
3.
Tempo Sync
Value: OFF, , , , , , , , , , , , , ,
Set this when synchronizing the Delay Time to the
song tempo. When not synchronizing, set this “OFF.”
When you select the note, the Delay Time is set to
match the length of the tone.
If the set note length is longer (or shorter) than the
possible range of delay time settings, the delay time
can not correspond to the note length. If “?” appears
before the note symbol you set, it is because the
upper (or lower) limit of the setting range has been
exceeded, and that the synchronization is not
correct. Furthermore, the precision of the delay time
and song tempo differ. If left to develop over long
periods, the two may drift apart.
Value Explanation
Small
Small amp
BuiltIn Built-in type amp
2Stack Stack of two large amps
3Stack Stack of three large amps
Value
Explanation
Mono
(Monaural) A single-input, single-out-
put delay
Alt
(Alternate) A single-in, dual-out stereo
delay in which the left and right outputs
are alternated (alternated delay).
ECS05_manual_e.book 427 ページ ２００５年１１月３０日 水曜日 午前１１時１４分