Filter
Top Products
74
Editing a sampled sound
3.
Adjust the Level and/or Pan parameters.
To adjust the level or pan of an audio phrase, press [F4 (AUX/Phrs/In)], and set the A.Phrase
parameters Level or Pan.
Specifying a fixed loudness when you strike the
pads
Here's how you can disable the velocity sensitivity of the pads.
1.
Press .
The indicator will light orange, and the FIXED VELOCITY function will be turned on.
In this state, the pads will produce a fixed velocity (default value = 127) regardless of
how strongly you strike them.
Using the pads to play accurate velocity levels
You can use the pads to play a single partial or audio phrase over sixteen steps of
velocity.
1.
Strike the whose sound you want to play over sixteen pre-determined
velocity levels.
The sound you play will be selected.
2.
Press .
The indicator will light orange, and the MULTILEVEL function will be turned on. In
this state, pad 1 plays a low velocity and pad 16 plays the maximum velocity.
The pad you strike determines which of the sixteen velocity levels are produced.
Holding the pressed state of a velocity pad
Here's how you can “hold down” a velocity pad without having to actually keep your
finger on it.
1.
Press and hold the pad you want to “hold.”
The sample of the pad will continue playing.
2.
While continuing to press the , press .
The HOLD indicator (red) will light, and the HOLD function will be turned on. Now
that pad will continue sounding even after you take your finger off of it.
Playing a roll
Here's how you can play a roll (rapidly repeated strikes).
1.
Press and hold , and strike the that you want to roll.
A roll will be played on the pad as long as you continue pressing [ROLL].
Pad
Velocity Pad Velocity Pad Velocity Pad Velocity
1
7 5 39 9 71 13 103
2 15 6 47 10 79 14 111
3 23 7 55 11 87 15 119
4 31 8 63 12 95 16 127
Use the top panel sliders 1~8
to adjust the Level.
You can set the velocity value
as desired. Refer to Fixed
Velocity level (p. 321).
To turn off the FIXED
VELOCITY function, press
[FIXED VELOCITY] once
again to make the indicator go
dark.
Your actual playing strength is
ignored while MULTILEVEL
is on.
To turn off the MULTILEVEL
function, press
[MULTILEVEL] once again to
make the indicator go dark.
To defeat HOLD, press
[HOLD] once again to make
the indicator go dark.
You can change the interval
(spacing) of the roll. Refer to
Pad Roll Interval (p. 321).
ECS05_manual_e.book 74 ページ ２００５年１１月３０日 水曜日 午前１１時１４分