Filter
Top Products
131
Creating an audio CD Project and disk management Using the MV8-OP1 (Audio I/O
Expansion) to connect external devices
Using data of other formats Using the MV-8000 with MIDI or V-LINK
devices
Creating an audio CD
Using the CD-R/RW drive
Cautions when using the CD-R/RW drive
• Place the MV-8000 on a stable and level surface that is not subjected to vibration by
external sources. If the unit is tilted significantly, this may adversely affect the
operation of the CD-R/RW drive.
• If you move the unit between locations of dramatically differing temperature and
humidity, condensation (water droplets) may form on the CD-R/RW drive. Using
the unit in this state will cause malfunctions; leave the unit for several hours to
allow the condensation to disappear before attempting to use it.
• Never attempt to use the emergency eject hole to eject the disc tray when the
MV-8000 is operating (when the MV-8000's DISK indicator or the CD-R/RW drive
access indicator are lit).
• Remove the disc from the disc tray before you turn the power on or off.
• Remove the disc from the disc tray when transporting the MV-8000.
• Do not place anything other than a disc bearing the logo (e.g., wires, coins,
any other type of disc) on the disc tray. Doing so will damage the CD-R/RW drive.
• Do not touch the lens. Doing so will make it impossible
for data to be read or written normally, and you may
experience skips during playback or recording.
• If the lens becomes dusty, you may clean it using a
commercially-available lens blower-brush sold for use
with camera equipment.
Cautions for CD-R/RW disc handling
• Do not use a conventional audio CD player to play back a CD-R/RW disc used to
back up a project. Doing so will produce a high-volume sound that can damage
your hearing and/or your speakers.
• Do not bend a disc, since this may make the disc unreadable or unwritable, and
may cause malfunctions.
• Do not drop or stack discs.
• Do not place heavy objects on a disc or subject it to strong impact.
• To hold a disc, insert your finger in the hole and grasp it
by the outer edge as shown in the diagram. Do not allow
fingerprints or scratches to occur on the recording surface
(the unprinted side), since this can make the data
unreadable.
• Do not use discs in excessively dusty locations.
• Do not leave discs in direct sunlight or in a closed
automobile.
• Do not leave a disc in the CD-R/RW drive for an extended time.
• To protect the disc, store it in its original case.
• Do not affix foreign objects such as labels to the label surface of the disc.
Emergency eject hole Eject button
Access indicator
Lens
ECS05_manual_e.book 131 ページ ２００５年１１月３０日 水曜日 午前１１時１４分