Filter
Top Products
188
Adding options
MV8-OP1 installation procedure
1.
Turn off the power of the MV-8000 and the connected devices, and
disconnect all cables from the MV-8000.
2.
Turn the MV-8000 upside down, and lay it on its face supported by objects at
each corner so that the panel buttons and knobs are not damaged.
3.
Remove sixteen screws from
the bottom panel and two
screws from the MV8-OP1
slot cover at the locations
shown in the illustration, and
detach the bottom cover and
the slot cover.
4.
Insert the MV8-OP1 into the
slot in the orientation shown
by the illustration.
5.
Plug the flat cable extending
from the MV8-OP1 firmly into
the connector on the main
board of the MV-8000.
6.
Use the two screws to fasten
the MV8-OP1.
7.
Use the sixteen screws to
fasten the bottom cover as it
was originally.
When you lay the MV-8000 on
its face, make stacks of
magazines or newspapers to
support each of the four
corners so that the weight of
the unit does not damage the
b
uttons and knobs. Make sure
that no pressure is being
applied to any button or knob.