Filter
Top Products
8. OPERATION PROCEDURES FOR THE SYSTEM MONITOR FUNCTION
8 - 2
MELSEC
GOT
8.2 Operation procedures from user-created monitor screen display to start of system monitoring
This section explains the operation procedure for the GOT when starting each
operation of the system monitor function, after the system program (OS) of the system
monitor function has been installed in the GOT built-in memory.
Start
(
∗
1)
!!!
Start up the GOT
Start the system monitor function.
Touch display position of monitor function to be selected.
See Sec. 9.1 for common operations.
Display monitor screen of selected function.
The procedure for testing is as follows:
!
Set/reset bit device.
!
Change current values of word device.
!
Change current value, set values of T or C.
Display the user-created monitor screen.
Execute operation for selected monitor function.
!!!
To Sec. 9.6.
T
o Sec. 9.2. To Sec. 9.3.
To Sec. 9.4. To Sec. 9.5.
!!!
DEV MON
END
BAT MON TC MON
BM MON
DEV MON
END
BAT MON TC MON
BM MON
DEV MON
END
BAT MON TC MON
BM MON
DEV MON
END
BAT MON TC MON
BM MON
Display the system monitor initial scren.
!!!
!!!
Touch the key where the touch switch (expanded) function was
set with the drawing software, and start the system monitor function
.
When the Utility screen is displayed, touch PLC. MON. to start the
s
y
stem monitor function.
*1
DEV MON
BAT MON
TC MON
BM MON
The A985/97*/960GOT displays 4 divided windows.
Operation for each window is described.
The A95*GOT displays 1 window.
When END is selected in any window, the system
monitor ends and the display moves to the original
screen where the system monitor function started.
SET
TEST