Filter
Top Products
4. OPERATING THE UTILITY FUNCTION
4 - 8
MELSEC
GOT
(2) Functions
•
Buzzer volume
You can select the length of the beep sound.(Factory-set to SHORT)
•
Outside speaker sound
You can select whether or not voice output is provided from the external speaker
(only the voice specified for the touch input sound on the drawing software).
(Factory-set to OFF)
•
Screen save time
Set the time until the monitor screen display is switched off by the screen saver function.
When this setting is "0", the monitor screen is always displayed.(Factory-set to 0)
•
Screen save light
When this setting is OFF, the backlight goes off as soon as the display is erased
by the screen saver function.
When this setting is ON, the display will disappear but the backlight will not go off.
•
Reverse display
The display mode (normal display (No)/highlighted display (Yes)) is selected.
(Only A95*GOT-LBD (-M3) can be selected. Normal display is set at the time of
shipment.)
•
Language
You can select the language (Japanese or English) of the messages to be
displayed on the screen. (Factory-set to Japanese)
•
QBUS extension number
Set the GOT extension number for bus connection to the QCPU.
(Factory set to extension 7)
•
QBUS slot number
Set the slot number where the GOT is assigned for bus connection to the QCPU.
(Factory set to slot 0)
•
Microcomputer connection baud rate
You can select the transmission speed when the GOT is connected to a
microcomputer.(Factory-set to 19200)
•
Microcomputer connection communication form
You can select the protocol when the GOT is connected to a microcomputer.
(Factory-set to FORM-1)
•
QC24 Baud rate
Set the transmission speed for connection with the QC24N.
(Factory-set to 19200bps)
•
Baud rate
Set the transmission speed for connection with the Yaskawa PLC or SIEMENS
PLC. (Factory-set to 19200bps)
•
Adapter address
Specify the MPI address on PROFIBUS assigned to the HMI adapter connected
to the GOT for SIEMENS PLC connection. (Factory-set to 1)
•
Host (FF) address
Specify the MPI address on PROFIBUS assigned to the PLC CPU to which the
HMI adaptor is connected for SIEMENS PLC connection.
The specified PLC CPU is the "host" when monitor device setting is made on the
drawing software.
For details of monitor device setting, refer to the help function of SW4D5C-
GOTR-PACKE. (Factory-set to 2)