Filter
Top Products
9. OPERATION OF THE VARIOUS SYSTEM MONITOR SCREENS
9 - 13
MELSEC
GOT
9.4.2 TC Monitor screen display and key functions
In this section, the TC Monitor screen display contents and the function of keys
displayed at the top of the screen are explained.
(1) Display
1)
T 0 PV 0 SV 0
[Production line A]
T 1 PV 0 SV 0
[Production line B]
T 2 PV 150 SV 150
[Production line C]
T 3 PV 0 SV 0
[Production line D]
NETWK No.[ 0] STATION[33]
FILE [ABCDEF.PRG]
TC MONITOR
TEST MENU FORM SET
2)
3)
When comment is not displayed: max. 8 devices
When comment is displayed : max. 4 devices
Display when system monitoring
T/C
current value, set value
(Contact point, coil)
:
ON
: OFF
1)
Displays the keys that are used with the operation of the TC Monitor screen
shown in (2) (Touch input).
2)
Displays the monitor station network No. and station No.
When connected to QnACPU, the execution file name is displayed (If there
are more than one file, the first file name is displayed.).
3)
Displays the current value, set value, contact point and coil status of the
monitor device (The screen above shows when the monitor module is 16
bits.).
(2) Key functions
The chart below shows the function of the keys that are used with the operation of
the TC Monitor screen.
Key Function
MENU
Move to basic screen (function change menu screen) for changing to
another monitor function or ending the system monitor (See Sec.
9.1.1.).
FORM
Move to display change menu screen for changing the numerical
display on the TC monitor screen (decimal/hexadecimal) or changing
the comment display (on/off) (See Sec. 9.1.2.).
SET
Move to device setting menu screen to change the monitor device or
execute a test.
•
Change of monitor device (See Sec. 9.1.3)
•
Test (See Sec. 9.6.)
Scroll the display contents up or down one line to display the monitor
device that is not displayed (just before or after the current display).
Operation is enabled when monitor device comment is displayed.
: Scrolls down one line.
: Scrolls up one line.