Filter
Top Products
5. OPERATION PROCEDURES FOR THE LADDER MONITOR FUNCTION
5 - 2
MELSEC
GOT
5.2 Operation procedures from display of user-created monitor screen to start of ladder monitoring
This section shows the operation procedures for the GOT when starting each
operation of the ladder monitor function after the ladder monitor function system
program (OS) has been installed in the GOT built-in memory.
Start
!!!
The memory board applicable for the PLC
CPU at the monitoring destination is
installed on the GOT.
Start up GOT.
Start the ladder monitor function.
When not reading the
sequence program from
the PLC CPU
Display the ladder monitor screen. When you touch Mon. , the circuit monitor starts.
See Sec. 6.2
Touch PLCRD.
Touch Menu
See Sec. 6.1.2
Display the user-created monitor screen.
!!!
!
When reading the sequence program from
the PLC CPU
Read the sequence program that is
displayed on the ladder monitor screen.
1)
Display the PLC read screen.
Specify the PLC CPU for the ladder monitor
and the program to be read.
The PC program is read.
!!!
1)
See Sec. 6.1.1
!!!
!!!
(
∗
1)
With the drawing software, touch the key where the touch switch (expanded) function is set, and
start the circuit monitor function.
When the Utility screen is displayed, start the circuit monitor function by touching LADDER MON. .
*1