Filter
Top Products
19. OPERATION PROCEDURES FOR THE LIST EDITOR FUNCTION
19 - 3
MELSEC
GOT
19.2.1 Operation of keyword input
If a keyword is registered in the ACPU when the connected ACPU or the ACPU PLC
No. corresponding to the operation is changed, the GOT requests for input of the
registered keyword. Input the keyword registered in the ACPU and press the GO
key.
If a keyword is not registered in the ACPU, this operation is not required.
(The operation automatically changes to Selection of Function and Mode in 19.2.2.)
KEYWORD= [******]
KEYWORD= [ OK ]
KEYWORD= [ NG ]
KEYWORD= [ ]
* NOW READING PLC
PLESE WAIT A MOMENT
MOTION CONTOROLLER
NOT SUPPORTED
When the keyword
(040411) is input
When the input keyword
is correct
When the input keyword
is not correct *1
Start the list editor function.
(* shows communication status with the PLC CPU.)
Input of the keyword is requested.
Input the keyword registered in the connected
ACPU and press the GO key.
The GOT checks the input keyword and displays
the result.
The check result display time is about 2 seconds.
If an incorrect keyword is input
Input the keyword to 6 letters
maximum with the device
No./constant setting key.
("0" to "9", "A" to "F")
To Mode Selection in 19.2.2
040411
GO
*1 When the input keyword does not match with the registered keyword, only
the following operations in Chapter 20 can be allowed.
Error step reading
Buffer memory overall monitor
Time monitor
PLC No. setting
Other modes
Main/sub switching
POINTS
•
For operations not shown in other modes, clear (delete) the registered keyword
with the "PLC memory all clear" in the following page if you do not remember
the keyword registered in the ACPU. When "PLC memory all clear" is
performed, the user data including sequence program is also cleared.
•
The keyword registered in the ACPU can be changed or a new keyword can
be registered as shown in Chapter 20.