Filter
Top Products
12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN
12 - 3
MELSEC
GOT
12.1.3 Setting method for remote station monitoring
The setting method to perform remote station monitoring during special module
monitoring is described below.
<Special Module Monitor>
Touch
SP.UNIT
to display the system configuration screen.
Depending on the connection method, the screen first
displayed will be different as indicated below.
Bus connection and CPU direct
connection
The base of the connection station
is displayed.
MELSECNET (II), /B connection No system configuration display
MELSECNET/10 connection No system configuration display
2
)
1)
When connected to MELSECNET
for MELSECNET connections, the following operations will always be
required:
1) Touch
NETPCNo.
to display the window shown in 2)
2) Touch
Alphanumeric
to specify the network No. and PLC station
No..
Alphanumeric
.. Enter the network No. and PLC station No..
................. Select the input area.
............. Set the area value.
In the case of data link systems
NETWK NO. : 0
STATION : FF (Host)
: 0 (Master station)
: 1 to 64 (Local station)
In the case of network systems
NETWK NO. : 0 (Host loop)
: 1 to 255 (Specified loop)
STATION : FF (Host)
: 0 (Station number
of management
station)
: 1 to 64 (Normal station)
When the setting is finished, the system configuration of the specified station is
displayed.
See Sec. 12.1.4 for operations which come after these operations.