Filter
Top Products
15. OPERATING THE NETWORK MONITOR FUNCTION
15 - 1
MELSEC
GOT
Chapter15 Operating the network monitor function
This chapter describes how to operate the network monitor function.
15.1 Steps in getting started with the network monitor function
The following flowchart outlines how to transmit and install an operating system (OS)
for the network monitor function in the GOT internal memory using the Personal
computer.
For further information on screen displays and key operations, see the online help of
the drawing software.
Start
The GOT does not require further setup
procedures or operations after the startup.
Transmit the data in the installation dialog box.
After the installation is complete, a message indicating
"End" appears in the installation dialog box.
Proceed to Section 15.2 to operate the network monitor
.
Connect the GOT and the Personal computer.
Start up the GOT.
!!!!!
Start up the Personal computer and start the
drawing software.
With the drawing software, transmit the OS for
the network monitor function from the Personal
computer to the GOT and install it in the built-in
memory.
!!!!!
After the installation is finished, the network
monitor is ready to start through the GOT.
!!!!!
Finish operating the drawing software.
Exit.
!!!!!
15