Filter
Top Products
3. SPECIFICATIONS
3 - 4
MELSEC
GOT
3.3 Special module monitor function specifications
POINTS
•
The memory board is required to use the special unit monitor function on the
A985/97*/960GOT.
•
The special unit monitor function cannot be used on the A95*GOT.
3.3.1 Access ranges to be monitored
(1) When using bus connection/CPU direct connection/computer link connection
!
The special function modules on the bases of the connected station and other
stations can be monitored.
(2) When using MELSECNET(II) connection/MELSECNET/B connection
!
The special function module on the base of the master station can be monitored.
(Cannot be monitored when the master station is the QnACPU.)
!
The special function modules on the bases of local stations cannot be monitored.
(3) When using MELSECNET/10 connection
!
The special function modules on the bases of the control station and normal
stations can be monitored.
(Cannot be monitored when the stations are the QnACPU.)
(4) When using CC-Link connection (remote device station)
!
The special function modules cannot be monitored.
(5) When using CC-Link connection (intelligent device station)
!
The special function modules on the bases of the master and local stations can
be monitored.
(6) When using the system configuration where remote I/O stations exist
!
The special function modules cannot be monitored in any connection form.
3.3.2 Special function modules to be monitored
The modules for which special function monitoring can be done are only those types
shown in Section 3.3.3.
Monitoring of special function modules other than those can be done with the system
monitor function "BM Monitor".