Filter
Top Products
12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN
12 - 7
MELSEC
GOT
12.1.6 Changing the screen
This section describes how to change the screen when executing each monitor
function of the special module monitor function from the status where the user-created
monitor screen is displayed.
(
∗
1)
Start
User-created monitor screen
Touch
Utility screen
The system monitor function and special module monitor
function can also be started from the Utility menu screen.
Touch
Touch
System Configuration screen
(See Sec. 12.1.1.)
Touch
sys.conf.
Touch on display module.
When I/O module is selected
When special function
module is selected
Touch on
monitor menu.
Touch
MONIT MENU
Touch DataChg.
and SET/RESET
Touch END
Go to user-created monitor screen
or utilit
y
screen.
1)
Touch the key where the touch switch (expanded)
function was set with the drawing software, and start
the special module monitor operation.
When the Utility screen is displayed, touch SP.UNIT
and start the special module monitor function.
∗
1
Touch
!!!!!!!!!
(
∗
1)
Key window display screen
for test
(See Sec. 12.1.5.)
Monitor screen for specified
monitor menu
(See Sec. 12.1.2.)
1)
Monitor menu display screen
for specified module
(See Sec. 12.1.4.)
END
SP.UNIT