Filter
Top Products
10. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
10.2 Communication Detail Setting
10 - 9
9
UTILITY FUNCTION
10
COMMUNICATION
INTERFACE SETTING
(COMMUNICATION SETTING)
11
DISPLAY AND
OPERATION SETTINGS
(GOT SET UP)
12
CLOCK SETTINGS AND
BATTERY STATUS DISPLAY
(TIME SETTING AND DISPLAY)
13
FILE DISPLAY AND
COPY (PROGRAM/DATA
CONTROL)
14
GOT SELF CHECK
(DEBUG AND SELF
CHECK)
15
CLEANING DISPLAY
SECTION (CLEAN)
16
INSTALLATION OF
COREOS, BOOTOS
AND STANDARD
Assign Ethernet I/F
Several drivers are assigned to the same Ethernet interface. However, only one GOT IP address is assigned per
interface.
By changing the settings of one interface, the GOT IP address, GOT port No. download, default gateway and subnet
mask settings of other drivers, which are assigned to the same interface, are also changed.
POINT
POINT
POINT
Communication parameter setting by drawing software
Select [Common Settings] [Communication Settings] from GT Designer3 to enter the communication
parameters for each communication driver.
When changing the communication parameters after downloading project data, change the setting at
communication detail setting of GOT.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
1. Touch the [Assign Ethernet I/F] button in
Communication Setting.
2. Touch the driver display BOX of the communication
parameter to be set in Ethernet I/F assignment.
3. The screen switches to the [Communication Detail
setting] screen.
Set communication parameters from this screen.
For the setting change operation, refer to the
following.
9.3.3 Basic operation of settings change