Mitsubishi Electronics GOT1000 Stereo Equalizer User Manual


 
14 - 20
14. GOT SELF CHECK (DEBUG AND SELF CHECK)
14.3 System Alarm Display
Operation of system alarm display
(1) System alarm display resetting
POINT
POINT
POINT
(1) Before resetting the system alarm display in the GOT error
Eliminate the system alarm cause before resetting the system alarm display in the GOT error.
If not eliminated, the system alarm display in the GOT error will not be reset even after the reset operation.
(2) Processings with reset operation
The following data in the system information are also reset.
GOT error code (Write device)
GOT error detection signal (System Signal 2-1.b13)
1. Eliminate each cause of the system alarm being
occurred.
Error causes can be identified by the error code,
error message and channel No. displayed on the
System alarm screen.
(
18. TROUBLESHOOTING)
2. A method for resetting system alarm depends on an
error.
GOT error
Touch [Reset] button to reset system alarms.
CPU error and Network error
The system alarm is automatically reset after its
cause is eliminated.
Touch