Filter
Top Products
16 - 12
16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
16.5 CoreOS
Installing the CoreOS
1. Write the CoreOS from GT Designer3 to the SD
card.
For details of GT Designer3 operation, refer to the
following manual.
GT Designer3 Version1 Screen Design
Manual (Fundamentals)
2. After confirming that the GOT is powered off, install
the SD card in the GOT. After installing, switch the
SD card access switch on.
3. Powering the GOT on displays the screen on the
left.
To cancel the installation, power the GOT off and
remove the SD card.
4. Turning the SD card access switch off executes
CoreOS installation.
5. When the installation is completed, the dialog as
shown on the left is displayed.
(The POWER LED of the GOT blinks (green/
orange) at the installation completion.)
6. Confirm that the message is displayed and power
the GOT off.
7. Remove the SD card after powering the GOT off.
8. Powering the GOT on again displays the screen as
shown on the left.
(The GOT goes to the status of factory shipment.)
Install OS (Standard monitor OS, communication
driver, etc.) or download project data as required.