Filter
Top Products
5 - 6
5. UL, cUL STANDARDS AND EMC DIRECTIVE
5.2 EMC Directive
POINT
POINT
POINT
Any device which utilizes a data communication function is susceptible to the wider effects of local EMC noise.
Therefore, when installing any communication cables care should always be taken with the routing and location of
those cables.
Optional ferrite cores are recommended when the cable route is close to EMC noise sources like welders, large
motors, etc.
All tests have been performed with original Mitsubishi cables. For customer prepared cables, please refer to the
previous page.
Example 1
GOT Unit Existing Cables User Made Cables
GT1450-QLBD
GT1450-QLBDE
GT1455-QTBD
GT1455-QTBDE
Ex. GT01-C30R4-8P (as shown in EX.1)
3
rd
party cables need to be independently
tested by the user to demonstrate EMC
compliance.
100mm(250mm)
140mm
GT01-C30R4-8P
Comes equipped
Optional
GOT units
F = Ferrite core
Ex. NEC TOKIN - ESD-R-17S or similar
Programmable
controller
Optional
(9.84inch)
(3.93inch)
(5.51inch)
F F F