Filter
Top Products
10 - 2
10. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
10.1 Communication setting
10.1.3 Communication setting contents
This section describes setting items and display contents for Communication Setting.
(1) Channel-Driver assign
Channel No. can be assigned to the communication driver installed in the GOT.
(a) Not writing [Communication Setting] in drawing software
Without writing [Communication Setting] in drawing software, communication with a controller is available
after assigning the channel No. with this function.
10.1.4
■ Channel-Driver assign operation
(b) When changing the assignment of the communication driver to the channel in the Utility
Without using drawing software, the assignment of communication drivers to channels can be changed.
(When changing a communication driver, the alternative communication driver has to be installed in GOT in
advance.)
(2) Standard interface display BOX
Display the communication interface included as standard in GT14. There are the following 4 types.
RS-232................. For communicating with PC (drawing software), bar code reader, RFID, controller or controller
RS-422/485.......... For communicating with controller
USB...................... For communicating with PC (drawing software)
Ethernet................ For communicating with PC (drawing software) or controller
(3)
(2)
(4)
(2)
(4)
(6)
(2)
(4)
(2)
(4)
(3)
(3)
(5) (1)
USB interface (Standard interface)
[GOT front face] [GOT rear face]
RS-422 interface (Standard interface)
RS-232 interface (Standard interface)
Ethernet interface (Standard interface)