Filter
Top Products
9. UTILITY FUNCTION
9.1 Utility Execution
9 - 1
9
UTILITY FUNCTION
10
COMMUNICATION
INTERFACE SETTING
(COMMUNICATION SETTING)
11
DISPLAY AND
OPERATION SETTINGS
(GOT SET UP)
12
CLOCK SETTINGS AND
BATTERY STATUS DISPLAY
(TIME SETTING AND DISPLAY)
13
FILE DISPLAY AND
COPY (PROGRAM/DATA
CONTROL)
14
GOT SELF CHECK
(DEBUG AND SELF
CHECK)
15
CLEANING DISPLAY
SECTION (CLEAN)
16
INSTALLATION OF
COREOS, BOOTOS
AND STANDARD
9. UTILITY FUNCTION
Utility is a function, which carries out connection of GOT and PLC, screen display and operation method settings,
program/data control and self-check etc.
For the utility function list, refer to the following.
9.2 Utility Function List
9.1 Utility Execution
For utility execution, utility has to be displayed by installing BootOS and Standard monitor OS in the C drive (Flash
memory).
There are following three types for the installing Standard monitor OS methods.
*1 When installing the BootOS and standard monitor OS, standard monitor OS has to be installed in GOT in advance.
For the installation which uses GT Designer3, refer to the following.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
For the installation which uses GOT, refer to the following.
16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
USB interface or
Ethernet interface or
RS-232 interface
BootOS or Standard monitor OS installation
BootOS or Standard
monitor OS installation
BootOS or Standard
monitor OS installation
Installed directly from GT Designer3
SD card or
USB memory
GT Designer3
GT Designer3
OS file
write
1) GT Designer3 GOT
OS file
upload
Install the SD
card or USB
memory in GOT
Install the SD
card or USB
memory in GOT
When GOT is remote, installed easily
using the SD card or USB memory
Install OS from GOT to GOT using
SD card or USB memory
3) GOT GOT
SD card
or
USB memory
SD card
or
USB memory
2) GT Designer3 GOT
*1
*1
SD card or
USB memory
*1