Filter
Top Products
Recommended Test Equipment
The following table lists the recommended equipment needed to test the performance
of the Agilent 35670A Dynamic Signal Analyzer. The table on page 1-20 lists
additional equipment needed to adjust and troubleshoot the analyzer. Other equipment
may be substituted for the recommended model if it meets or exceeds the listed critical
specifications. When substitutions are made, you may have to modify the procedures
to accommodate the different operating characteristics.
Recommended Test Equipment
Instrument Critical Specifications Recommended Model
AC Calibrator 10 Hz to 102.4 kHz; 1 mV to 10 V
Amplitude
Amplitude Accuracy: ±0.1% phase locking
capability
Fluke 5700A †
Alternate
Fluke 5200A †
Datron 4200, 4700, or 4708 ‡
HP 745A
Frequency
Synthesizer
Frequency Range: 10 Hz to 1 MHz
Frequency Accuracy: ≤5 ppm
Amplitude Accuracy:
0.2 dB from 1 Hz to 100 kHz
1 dB from 100 kHz to 1 MHz
Harmonic Distortion: ≤–70 dBc
Spurious: ≤–70 dBc
<±1 deg phase shift between output and
sync
HP 3326A
Alternate
(2) HP 3325A/B Opt 001
Low Distortion
Oscillator
Frequency Range: 10 Hz to 100 kHz
Harmonic Distortion: ≤–93 dB, 10 Hz to
20 kHz
HP 339A ††
Alternate
HP 3326A with notch filter ††
HP 3325A/B with notch
filter††
Digital
Multimeter
5 1/2 digit True rms ac Voltage:
30 Hz to 100 kHz; 0.1 to 500 V; ±0.1%;
≥1MΩ input impedance dc Voltage:
1 V to 300 V; ±0.1%
HP 3458A
Alternate
HP 3456A , HP 3455A
HP 3478A
Feedthrough
Termination (2)
(4 for option
AY6)
50 Ω: ±2% at dc
Pomona Elect Model 4119-50
‡‡
Alternate
HP 11048C, HP 10100C
† John Fluke Manufacturing Co., Inc., PO Box C9090, Everett, WA 98206 U.S.A. (206) 347-6100
‡ Wavetek, 5808 Churchman Bypass, Indianapolis, IN 46203 U.S.A.
†† This equipment is not required for Operation Verification. The parts and schematic for the notch
filter are shown on page 1-19.
‡‡ ITT Pomona Electronics, 1500 East Ninth Street, Pomona, CA 91769 U.S.A. (714) 469-2900
FAX (206) 629-3317
Agilent 35670A Specifications
Recommended Test Equipment
1-17