Filter
Top Products
Configuration and Use Manual 33
Configuring System Data Configuring APIConfiguring InputsConfiguring Security & Language
Chapter 5
Configuring Security and Language
5.1 About this chapter
This chapter explains how to configure security and select the language for the Series 3000 display.
Security and language parameters are listed in Figures 5-1 and 5-2
.
Failure to perform configuration tasks in the proper sequence could result in an incomplete
configuration. See Section 1.7 for the recommended configuration sequence.
5.2 Security menu
Use the Security menu, shown in Figure 5-1, to access and configure security and passwords. The
Security menu is accessed through the Management menu, as described in Chapter 4.
To configure security for weights and measures (custody transfer) applications, see Chapter 14.
Figure 5-1 Security menu
CAUTION
Changing configuration can affect device operation.
Set control devices for manual operation before changing device configuration.
Security
Maintenance
• Press 1
• Press 2
• Press 3
• Press 4
Security Passwords Weights & Measures
(2)
(see Chapter 14)
Configuration
• Press 1
• Press 2
• Press 3
• Press 4
Enable security
Write protect
(1)
Totalizer reset
(1)
(1) Displayed only if the custody transfer application is not installed.
(2) Displayed only if the custody transfer application is installed.
(3) Displayed only if World Area is set to OIML.
Alarm log
(2)(3)
(see Chapter 14)