Filter
Top Products
Configuration and Use Manual 293
ProLink II and Pocket ProLink
375 Field Communicator Safety LabelsSample TicketsProLink II
Figure G-2 ProLink II configuration menu
Flow
• Flow direction
•Flow damp
•Flow cal
• Mass flow cutoff
• Mass flow units
• Vol flow cutoff
(1)
• Vol flow units
(1)
• Vol flow type
• Std gas vol flow cutoff
(2)(3)
• Std gas flow units
(2)
• Std gas density
(2)
Gas wizard
(2)
• Mass factor
• Dens factor
• Vol factor
• Flow switch variable
• Flow switch setpoint
Density
• Density units
• Density damping
• Slug high limit
• Slug low limit
• Slug duration
• Low density cutoff
•K1
•K2
•FD
•D1
•D2
• Temp coeff (DT)
Temperature
• Temp units
• Temp cal factor
• Temp damping
• External temperature
Pressure
•Flow factor
• Dens factor
• Cal pressure
• Pressure units
• External pressure
ProLink >
Configuration
Additional configuration options
Device
•Tag
•Date
•Descriptor
•Message
• Sensor type
• Transmitter serial number
• Floating pt ordering
• Add comm resp delay
Digital comm settings
• Fault setting
• HART address
• Loop current mode
• HART device ID
• Modbus address
• Enable write protection
Update rate
• Response time
Burst setup
• Enable burst
• Burst cmd
• Burst var 1...4
T Series
• FTG
• FFQ
•DTG
•DFQ1
•DFQ2
•K3
•D3
•D4
•K4
Display
Screen 1
• Var 1...4
Screen 2
• Var 1...4
Screen 3
• Var 1...4
Screen 4
• Var 1...4
Screen 5
• Var 1...4
Display precision
•Var
• Number of decimals
• Custody transfer approved
Display language
Restore factory configuration
(1) Displayed only if Volume Flow Type = Liquid Volume.
(2) Displayed only if Volume Flow Type = Gas Standard Volume.
(3) Displayed only on systems with the enhanced core processor.