Filter
Top Products
296 Micro Motion
®
Series 3000 MVD Transmitters and Controllers
ProLink II and Pocket ProLink
Figure G-5 ProLink II configuration menu continued
ProLink >
Configuration
Printer
Printer
•Type
• Data bits
• Chars/sec
• Buffer size
• Disable paper out detection
Ticket
• Batch start number (BOL)
• No. of batch tickets
• Transfer start (BOL)
• Transfer type
• No. of transfer tickets
• Transfer type
• Use form feed
• Print with non-zero flow
• Alarm occurrence on transfer
ticket
Header and footer
• Pre header
• Line #1 … #4
• Line feeds #1 … #4
• Font size #1 … #4
•Footer line
• Post footer
• Footer line feeds
• Footer font size
Print request configuration
• Process monitor with statistics
• Process monitor
• Monitor screen 1 … 5
• Batch ticket
• All configuration data
• Alarm history
• Active alarm log
• Audit trail event log
• Printer test
• Alarm event log
API setup
(1)
• Table type
•Units
Discrete batch
(2)
Flow source
Control options
· Enable batch
· Count up
· Enable AOC
· Lockout target
· Auto print at batch end
· Reset on start
· Enable end warning
· Enable overrun
· Ignore source alarms
· No-flow timeout
· Number of stages
· Number of decimals
· Maximum target
·Alarm timeout
· Configure presets by
Configure presets
· Preset number
·Preset name
· Enable preset
· Open primary
· Open secondary
· Close primary
·End warning
· Density curve
· Overrun
· Preset target
ED setup
(3)
Global config
· Active curve
· Derived variable
· Reset all curve info
· Lock/unlock ED curves
Curve specific config
· Curve configured
· Curve name
· Reference temperature
· Water reference temperature
· Water reference density
·Trim slope
· Trim offset
Extrapolation
· Alarm limit
· Enable density low
· Enable density high
· Enable temperature low
· Enable temperature high
Concentration
·Units
· Special unit string
ED curve
(3)
Process fluid density at specified temperature
and concentration
· Curve being configured
· Curve fit max order
· Temperature isotherms
· Concentration points
· Curve data points
Curve fit results
·Accuracy
Process fluid density at reference temperature
and specified concentration
· Reference temperature
· Concentration points
· Curve data points
(1) Displayed only if the petroleum measurement application is installed.
(2) Displayed only if the discrete batch application is installed.
(3) Displayed only if the enhanced density application is installed.