Filter
Top Products
Configuration and Use Manual 145
Operation Mode
Operation Mode – Batch Totalizers and InventoriesOperation Mode – Custody TransferOperation Mode
17.5 Using the View menu
When you press
VIEW at the operation screen, the View menu is displayed (see Figure 17-2).
This menu varies according to the installed applications. Your menu may be different.
Note: See Chapter 19 for a discussion of the View menu if the custody transfer application is installed
and World Area is set to OIML.
Figure 17-3 shows the functions performed by the function buttons and cursor control buttons in the
View menu.
Figure 17-2 View menu
View menu
Active alarm log Process
monitoring
Preset
selections
(1)
Preset 1
Preset 2
Preset 3
Preset 4
Preset 5
Preset 6
Batch inventory
(1)
Preset inventory 1
Preset inventory 2
Preset inventory 3
Preset inventory 4
Preset inventory 5
Preset inventory 6
Process totalizers
Process
• Mass total
• Volume total
• API ref vol total
(3)
• ED ref vol total
(4)
• ED net mass total
(4)
• ED net vol total
(4)
• Frequency input total
Inventory
• Mass inventory
• Volume inventory
• API ref vol inventory
(3)
• ED ref vol inventory
(4)
• ED net mass inventory
(4)
• ED net vol inventory
(4)
• Freq input inventory
Diagnostic monitor
Tube frequency
Left pickoff
Right pickoff
Drive gain
Live zero
Density curves
(2)
Density curve 1
Density curve 2
Density curve 3
Density curve 4
Density curve 5
Density curve 6
LCD options
Contrast
LCD backlight
Applications list
(1) If batch application is installed and configured.
(2) If enhanced density application software is installed and configured, and density curves have not been assigned to batch presets.
(3) If petroleum measurement application is installed and configured.
(4) If enhanced density application software is installed and configured.