Configuration and Use Manual 115
Configuring Custody Transfer
Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications
14.7 Installing the weights and measures seal
The weights and measures seal must be installed and secured by a weights and measures inspector or
authorized third party.
• On a panel-mount Model 3300 or Model 3500, the inspector runs the wire seal through the
custody transfer tab, as shown in Figure 14-3.
• On a rack-mount Model 3300 or Model 3500, two locations are provided for the weights and
measures seal:
- Required: The inspector must run a wire seal through the custody transfer tab, as shown in
Figure 14-4.
- Optional: The inspector may run a wire seal through the holes in the lockout screws on the
front panel of the platform, as shown in Figure 14-5.
• On a field-mount Model 3350 or Model 3700, a hasp on the housing is located beside the
circuit board compartment cover. The cover has four tabs. The inspector runs the wire seal
through the hole in the hasp and the hole in the nearest tab, as shown in Figure 14-6.
