Configuration and Use Manual 121
Ticket Formatting and Printing
Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications
Note: You can assign one or more actions to a single discrete input or discrete event. Other discrete
input and discrete event actions and assignments are listed and defined in Table 7-14. Note that if you
assign ticket printing to a discrete input or a discrete event, all standard, batch, batch (NTEP), and
batch (OIML) tickets will be printed, but if a transfer (OIML) ticket is assigned with other ticket
types, only the transfer (OIML) ticket will be printed. If required, assign the transfer (OIML) ticket to
one discrete input and assign all other tickets to the second discrete input.
15.4 Batch tickets
This section describes the formatting and printing of batch tickets.
15.4.1 Formatting
To format batch tickets:
1. In the Digital Communication menu, select
Configure RS-485 and set Protocol to Printer.
The menu shown in Figure 15-2 is displayed.
2. Select
Configure Printer.
3. Set parameters as desired. See Table 15-4.
Note: Other parameters in this menu are defined in Table 13-3.
Note: The Header Line 1, Header Line 2, and Footer parameters are shared with all ticket types. Any
formatting defined for batch tickets is applied to all tickets.
Figure 15-2 Ticket configuration menu – Batch tickets
Digital comm
Configure RS-485
Protocol
•HART
•Modbus RTU
•Modbus ASCII
• Printer
Discrete inputs
• Print screen
• Screens to print
• Print process monitor
Configure printer
• Printer selection
• Pre header codes
• Header line 1 – 2
• Footer
• Post footer codes
• Baud rate
•Parity
• Data bits
• Stop bits
• Chars per second
•Print buf size
• Lines per page
• Number of tickets
• Auto print
• Disable paper check
(1)
Printer test
(1) Not displayed if custody transfer application is installed
and World Area is set to OIML.
