Filter
Top Products
Configuration and Use Manual 297
375 Field Communicator Safety LabelsSample TicketsProLink II
Appendix H
375 Field Communicator
H.1 Overview
This appendix provides basic information for connecting and using the 375 Field Communicator with
your Series 3000 device. The following topics and procedures are discussed:
• Requirements – see Section H.2
• Connecting to a Series 3000 device – see Section H.3
• Communicator menus – see Section H.4
H.2 DD requirements
To use the 375 Field Communicator with a Series 3000 device, the following device description (DD)
must be loaded to your Communicator:
Micro Motion 3000 Mass flo v7 DD v2
This DD does not provide complete access to the Series 3000 features, functions, and data. For
complete access, use the Series 3000 display menus.
H.3 Connecting from the 375 Field Communicator to a Series 3000 device
To connect to the Series 3000 device:
1. Identify the primary mA output terminals on your Series 3000 platform.
See Figure 2-2 for the location of the terminal blocks on the different Series 3000 devices. See
Figure 2-3 to identify the terminals.
2. Attach the leads from the Communicator to the primary mA output terminals.
3. Add resistance as required.
4. Follow standard Communicator procedures to connect to the Series 3000 device.
H.4 Communicator menu flowcharts
This section contains flowcharts for most Communicator menus. These flowcharts are based on:
• Micro Motion 3000 Mass flo v7 DD v2
• Series 3000 device software rev7.0
The flowcharts start from the Communicator Online menu.