Filter
Top Products
Configuration and Use Manual 137
Startup Procedures
Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications
Figure 16-1 Calibration menu
2
Calibration
(1) Read-only; displayed for reference only.
(2) Displayed only if you are using the enhanced core processor and the
factory configuration has been saved.
(3) Displayed only if the discrete batch application is installed.
(4) Displayed only if the enhanced density application is installed.
Sensor zero
Density
(see Chapter 21)
Milliamp output 1
Batch AOC
(3)
(see Chapter 18)
Meter verification
(see Chapter 21)
Low density
• Density
•D1
• Calibrate density
High density
• Density
•D2
• Calibrate density
Flowing density
• Actual density
• Calibrate density
Density D3 (T-Series)
• Density
•D3
• Calibrate density
Density D4 (T-Series)
• Density
•D4
• Calibrate density
View current data
Uncertainty limit
Counter
Start meter verify
Zero time
Mass flow rate
(1)
Calibrate zero
Restore factory zero
(2)
View current data
Density curve trim
(4)
(see the enhanced density
manual)
mA output trim
Low temperature
• Low temp. value
• Calibrate temp.
High temperature
•High temp. value
• Calibrate temp.
View current data
Tri m 4.0 mA
• Enter mA reading
• mA output reads
• Does mA out match?
Trim 20.0 mA
• Enter mA reading
• mA output reads
• Does mA out match?
Temperature
(see Chapter 21)