Filter
Top Products
Configuration and Use Manual 321
NE 53 History
NE 53 History IndexReturn Policy
Software adjustment
Clarified range checking when writing D1 and D2 values for T-Series
sensors
Clarified posting of Start Not Okay alarm
Allow discrete batch to be started when milliamp output is fixed
Allow batch target to be changed from batcher process screen when
no decimal point is displayed (precision set to zero)
Removed printing of character when power is cycled
Allow batch preset selection to be changed when device is secured for
custody transfer.
Clarified use of HART command 180 for Model 3300 controller for
writing output fault parameters
Clarified default derived variable when standard curves feature is
enabled
Expanded range of frequency input total and frequency input
inventory
Feature addition
Added configurable alarm severity
Added gas standard volume functionality
Added support for meter verification option
11/2009 8.00 Software expansion 20001266CA
Added Field Verification Zero process variable
Updated meter verification to add support for “continue measurement”
option, scheduling, and execution from a discrete input or discrete
event
Added user-configurable hysteresis to flow switch
Added ability to configure pre header and post footer printer codes
when the custody transfer application is enabled but the transmitter is
not secured
Software adjustment
Support for HART command 139 modified to include unit checking
Response to a Modbus write command to coil 34 modified so that an
A028 alarm is no longer generated
Feature addition
Added support for Marine Bunker Transfer Package (refer to the
manual entitled Series 3000 Transmitters: Marine Bunker Transfer
Package Supplement, available on the Micro Motion web site at
www.micromotion.com)
Table L-1 Series 3000 device software change history continued
Date
Software
version
Changes to software
Operating
instructions