Filter
Top Products
Configuration and Use Manual 119
Ticket Formatting and Printing
Configuring Custody Transfer StartupConfiguring TicketsConfiguring Digital Communications
15.3 Standard tickets
This section describes the formatting and printing of standard tickets.
15.3.1 Formatting
To format standard tickets:
1. In the Digital Communication menu, select
Configure RS-485 and set Protocol to Printer.
The menu shown in Figure 15-1 is displayed.
2. Select
Configure printer.
3. Set parameters as desired. See Table 15-3.
Note: Other parameters in this menu are defined in Table 13-3.
Note: The Header Line 1, Header Line 2, and Footer parameters are shared with all ticket types. Any
formatting defined for standard tickets is applied to all tickets.
Note: Because the audit trail is a custody transfer feature and requires the custody transfer
application, audit event log tickets include the Header Line 3 and Header Line 4 parameters
configured for transfer tickets (see Section 15.6.1 or Section 15.5.1). In all other respects, audit event
log tickets are standard tickets.
Figure 15-1 Ticket configuration menu – Standard tickets
Digital comm
Configure RS-485
Protocol
•HART
•Modbus RTU
•Modbus ASCII
• Printer
Discrete inputs
• Print screen
• Screens to print
• Print process monitor
Configure printer
• Printer selection
• Pre header codes
(1)
• Header line 1–2
• Footer
• Post footer codes
(1)
• Baud rate
•Parity
• Data bits
•Stop bits
• Chars per second
• Print buf size
• Lines per page
• Number of tickets
(2)
• Auto print
(2)
• Disable paper check
(3)
Printer test
(1) Not displayed if custody transfer application is installed.
(2) Displayed only if discrete batch application is installed,
and applies only to batch tickets.
(3) Not displayed if custody transfer World Area is set to
OIML.