Filter
Top Products
28 Micro Motion
®
Series 3000 MVD Transmitters and Controllers
Using the Display and Menu System
Figure 4-5 Pressing Security button from Process Monitor screen – Security enabled
4.3.2 Shortcuts
From any point in the menu system, you can:
• Return to the Management menu (if security is disabled) or the password entry screen (if
security is enabled) by pressing the
Security button, as described in the previous section.
• Return to the operating screen by pressing the
Security button, then pressing the EXIT button.
4.4 Using the function buttons
The buttons at the bottom of the display are the function buttons. The functions performed by the
buttons vary, depending on the screen and the current state of the application. The function currently
assigned to the button is always displayed on the screen, above the button. The buttons are sometimes
referred to as F1, F2, and F3. See Figure 4-6.
Note: The left and right cursor control buttons may also be used as function buttons. See Figure 4-6.
If a cursor is shown on the display, the action performed by the function button applies to the item
where the cursor is located. Before pressing a function button, be sure the cursor is located correctly.
See Section 4.5.
Enter Password
SEL HELP EXIT
5← DEVICE 1 →2
Mass Flow Rate
2.33
g/s
Mass Total
485.88
g
PRINT RESET EXIT