Filter
Top Products
Configuration and Use Manual 25
Installation Using the DisplayDigital Communications SetupBefore You Begin
Chapter 4
Using the Display and Menu System
4.1 About this chapter
This chapter explains how to use the Series 3000 display and menu system. Using the display, you can
move through the menus, configure the application, monitor and control the application, and perform
maintenance and diagnostic tasks.
4.2 Startup display
When the Series 3000 device is powered on, it automatically tests its display. During display testing,
the screen darkens for approximately five seconds. After the display test is completed:
1. The Micro Motion logo is displayed for two to three seconds.
2. An application list is displayed for two to three seconds.
3. The device enters operation mode:
• If the discrete batch application is not installed, the process monitor screen is displayed, as
shown in Figure 4-1.
• If the discrete batch application is installed, the batch process screen is displayed (see
Figure 18-1).
Figure 4-1 Process Monitor screen
4. If there are any active alarms, the alarm category will be displayed in the alarm bar. To view,
acknowledge, or respond to the alarms, see Chapter 22.
5← DEVICE 1 →2
Mass Flow Rate
2.33
g/s
Mass Total
485.88
g
RESET EXIT
Security
button
Alarm bar
VIEW or EXIT
button