Filter
Top Products
Configuration and Use Manual 147
Operation Mode
Operation Mode – Batch Totalizers and InventoriesOperation Mode – Custody TransferOperation Mode
17.5.2 Process monitoring
This selection displays the process monitor, as described in Section 17.4. The display is identical to
the display shown in Figure 17-1.
If you enter the process monitor from the View menu, then press
EXIT, you are returned to the View
menu.
17.5.3 Preset selections
The Preset Selections option allows you to specify which of the existing presets will be used to
control batching. Only presets that have been enabled are listed here.
The discrete batch application can be set up with as many as six different batch presets. Each preset
has its own target. A preset may also have a descriptive name, which will appear on the selection
menu.
For more information on batch presets and how to configure them, see Section 11.6.
Note: If a density curve has been assigned to the selected preset, batch totals will be based on the
derived variable that was selected during configuration of the density application. See the enhanced
density manual.
17.5.4 Batch inventory
This option displays the current inventory totals for all enabled presets.
For more information on batch presets and how to configure them, see Section 11.6. For more
information on batch inventories and how to reset them, see Section 18.3.
17.5.5 Process totalizers and inventories
The View menu allows you to view, start, stop, and reset process totalizers, and view process
inventories.
To view or manage process totalizers:
1. From the View menu, select
Process Totalizers.
2. Select
Process. Current values for the first four totalizers are displayed. Scroll down as
required to view additional totalizers.
3. To start or stop all totalizers, press the left function button (labeled
START or STOP).
4. To reset a specific totalizer:
a. Highlight the totalizer to be reset.
b. Press the
RESET button.
To view a process inventory:
1. From the View menu, select
Process Totalizers.
2. Select
Inventory.
3. Scroll down the list as required to view the desired value.
Note: Inventories cannot be reset from the View menu. To reset an inventory, you must use the
Maintenance menu. See Section 20.5.