Filter
Top Products
Configuration and Use Manual 151
Operation Mode – Batch
Operation Mode – Batch Totalizers and InventoriesOperation Mode – Custody TransferOperation Mode
Figure 18-1 Series 3000 display in batch mode
18.3.1 Function buttons
In Figure 18-2, the display shows that the batch target is 12.3 kg.
• When you press
START, the discrete outputs assigned to the pump and valve are activated, and
flow starts.
• When the target amount has passed through the flowmeter, the discrete outputs assigned to the
pump and valve are deactivated, and flow stops.
The labels on the three function buttons are changed during the batch run to show the actions you can
perform at each point.
To start the batch, press the button on the left, labeled
START. Figure 18-2 shows what happens.
DEVICE 1
Preset 1
Actual
0.0
Target
kg
12.3
START HELP VIEW
Cursor control
buttons
Security
button
Editing
cursor
Backlit
display
Function buttons
Note: If the petroleum measurement application or the enhanced density application is installed
and the batch controller is measuring standard volume, net volume, or net mass, actual and
target values indicate net totals rather than gross totals.