Chapter 1 43
Preparing for Use
Installing Optional Measurement Personalities
The Exit Main Firmware key is used during the firmware installation
process. This key is only for use when you want to update core firmware
using a LAN connection. The
Exit Main Firmware key halts the operation
of the instrument firmware so you can install an updated version of
firmware using a LAN connection. Instructions for loading future
firmware updates are available at the following URL:
www.agilent.com/find/vsa/
Installing a License Key
To install a license key number for the selected option, use the following
procedure.
NOTE You can also use this to reinstall a license key number that has been
deleted during an uninstall process, or lost due to a memory failure.
1. Press
System, Install, Choose Option. The Choose Option key accesses
the alpha editor menu. Use the alpha editor to enter letters
(upper-case) and the front-panel numeric keys to enter numbers for
the option designation. Then press the
Done key. As you enter the
option, you will see your entry in the active function area of the
display.
NOTE You must already have entered the license key for the GSM option BAH
before you can enter the license key for the EDGE retrofit option 252.
2. Press
License Key. Enter the letters/digits of your license key. You
will see your entry in the active function area of the display. When
you have completed entering the license key number, press the
Done
key.
3. Press the
Install Now key.
The message “ New option keys become active after reboot.”
will appear. If you want to proceed with the installation, press the
Yes key and cycle the instrument power off and then on. Press the No
key if you wish to cancel the installation process.
a. This application uses the shared library, so you have to add its
memory requirements to this value.