Agilent Technologies E4406A VSA Satellite Radio User Manual


 
Chapter 5 347
Language Reference
SENSe Subsystem
SpectrumADC Dither
[:SENSe]:SPECtrum:ADC:DITHer[:STATe] AUTO|ON|OFF|2|1|0
[:SENSe]:SPECtrum:ADC:DITHer[:STATe]?
Turn the ADC dither on or off. This is an advanced control that
normally does not need to be changed.
Factory Preset
and *RST: AUTO
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
SpectrumADC Range
[:SENSe]:SPECtrum:ADC:RANGe
AUTO|APEak|APLock|M6|P0|P6|P12|P18|P24|
[:SENSe]:SPECtrum:ADC:RANGe?
Select the range for the gain-ranging that is done in front of the ADC.
This is an advanced control that normally does not need to be changed.
Auto peak ranging is the default for this measurement. If you are
measuring a CW signal please see the description below.
AUTO - automatic range
For FFT spectrums - auto ranging should not be not be used. An
exception to this would be if you know that your signal is
bursty. Then you might use auto to maximize the time domain
dynamic range as long as you are not very interested in the FFT
data.
Auto Peak (APEak) - automatically peak the range
For CW signals, the default of auto-peak ranging can be used, but
a better FFT measurement of the signal can be made by selecting
one of the manual ranges that are available: M6, P0 - P24.
Auto peaking can cause the ADC range gain to move
monotonically down during the data capture. This movement
should have negligible effect on the FFT spectrum, but selecting a
manual range removes this possibility. Note that if the CW signal
being measured is close to the auto-ranging threshold, the noise
floor may shift as much as 6 dB from sweep to sweep.
Auto Peak Lock (APLock) - automatically peak lock the range
For CW signals, auto-peak lock ranging may be used. It will find
the best ADC measurement range for this particular signal and
will not move the range as auto-peak can. Note that if the CW
signal being measured is close to the auto-ranging threshold, the
noise floor may shift as much as 6 dB from sweep to sweep.