112 Chapter 2
Programming Fundamentals
Using the LAN to Control the Analyzer
NOTE A convenient way to make a cross-over adapter is to use two RJ-45 jacks
wired according to Table 2-4. Standard straight-through patch cables
can then be used from the analyzer to the adapter, and from the adapter
to other LAN devices. If you use a special-purpose adapter, you will
avoid having a cross-over cable mistaken for a standard,
straight-through patch cable.
NOTE Some commercially-available cross-over cables do not implement the
cross-over wiring required for your analyzer. Please refer to Table 2-4,
and verify all connections before using cables not made by Agilent
Technologies.
Figure 2-7 Cross-Over Patch Cable Wiring (cross-over end)