Filter
Top Products
Chapter 5 315
Language Reference
SENSe Subsystem
Selecting a specific sweep time may result in a long measurement time
since the resulting number of data points my not be the optimum 2
n
.
Use [:SENSe]:ACP:OFFSet:LIST:SWEep:TIME to set the number of
points used for measuring the offset channels for Basic and cdmaOne.
For cdma2000 and W-CDMA, this command sets the sweep time when
using the sweep mode. See [:SENSe]:ACP:SWEep:TYPE.
Factory Preset
and *RST: 625
µs (1 slot) for W-CDMA (3GPP), W-CDMA (Trial &
Arib)
1.25 ms for cdma2000
11.20 ms for Basic, cdmaOne
Range: 500
µs to 10 ms
1
µs to 50 ms for Basic, cdmaOne
Default Unit: seconds
Remarks: You must be in the Basic, cdmaOne, cdma2000,
W-CDMA (3GPP), or W-CDMA (Trial & Arib) mode to
use this command. Use INSTrument:SELect to set the
mode.
History: Added to Basic revision A.03.00, to cdmaOne revision
A.04.00
Adjacent Channel Power—Automatic Sweep Time
[:SENSe]:ACP:SWEep:TIME:AUTO OFF|ON|0|1
[:SENSe]:ACP:SWEep:TIME:AUTO?
Sets the sweep time to be automatically coupled for the fastest
measurement time.
Factory Preset
and *RST: ON
Remarks: You must be in Basic, cdmaOne mode to use this
command. Use INSTrument:SELect to set the mode.
History: Revision A.03.00 or later, in cdmaOne revision A.04.00
Adjacent Channel Power—Sweep Type
W-CDMA (3GPP) mode
[:SENSe]:ACP:SWEep:TYPE FAST|FFT|SWEep
[:SENSe]:ACP:SWEep:TYPE?